Denali Plus CTR3 Instructions d'exploitation télécharger pdf (Page 12)

Page11 www.DENALIplus.com

Fig. 8

NOTE: CARRIER BRACKETS AND SELF ADHESIVE SEALANT ARE FACTORY INSTALLED.

Step #5 - Electrical Connection

Before proceeding further, verify that the power supply is disconnected. Verify that the

appropriate electrical supply requirements have been met. Refer to the table on page 2 for

appropriate electrical requirements. The cooktop is supplied with a 40-inch long conduit for a

connection to an accessible junction box. The conduit consists of three insulated wires. In 120V

units, there is a hot lead conductor (black insulated tinned copper), one insulated ground

conductor (green insulated tinned copper) and a neutral conductor (white insulated tinned

copper). In 240V units, there are two hot lead conductors (one red, one black insulated tinned

copper) and one insulated ground conductor (green insulated tinned copper).

Attach conductor wires to residence wiring in accordance with national, state and local electric

codes.

Grounding: The entire appliance must be grounded at all

times when the electrical power supply is on. Connect the red to red, black to black

and green to ground. Do not ground the appliance with the neutral house supply

wire. A separate ground must be used.

1 2 ... 7 8 9 10 11 12 13 14 15

Pas de commentaire

Denali Plus CTR3 Instructions d'exploitation Page 12